TRIGGER GUARD PIN KIT A1 LOWERS HK416 417 MR HAUS 🇺🇸

$4.05

Out of stock

Add to WishlistAdd to Compare

This trigger guard pin set will allow you to install an HK416 A5 trigger guard in a Non-ambi HK416 or 417 lower receiver.

🇺🇸 Made In USA

Installation Instructions

To install our A5 V2 style trigger guard use the short roll pin on the end of the trigger guard that the detent would normally go in. If you ever need to remove your A5 V2 style trigger guard, all you need to do is tap the short roll pin in until it clears the inner edge of the trigger guard “ear”, this will allow the trigger guard to swing down. At this point you can tap the short roll pin out of the trigger guard.