MUZZLE DEVICE WRENCH JMW FORWARD CONTROLS DESIGN

JMW is a combination wrench with a 3/4 wrench with a 0.23 thickness for the A2 compensator, and another 3/4 wrench  with a 0.20 thickness for Surefire suppressor mounts and Dead Air’s flash suppressors, compensators and brakes.

The 0.20 side is also suitable for use with Keymo, Key Micro mount and other suppressor mounts that have thinner than A2 spec (0.23) flats.

Most armorer’s wrenches have a rather thick 3/4 wrench for torquing the A2 compensator.  While adequate for the A2 compensator, this presents an issue with muzzle devices with thinner than A2 spec flats, an armorer wrench’s 3/4 wrench often can’t find enough clearance, and  is too thick for the flats which are sandwiched between the barrel and the muzzle device’s sound suppressor mounting interface.  To make things more complicated, some muzzle alignment shims can be of slightly larger outer diameter than the barrel.  A typical 3/4″ wrench often can’t be used to torque these muzzle devices.

Billet machined in 4140, heat treated and black oxided, it has the recommended torque value (20 to 30 ft/lb) laser engraved.

Made In USA